Iowa Department of Transportation Office of Design 21A-21 Design Manual Chapter 21 Automation Tools Instructions Originally Issued: 11-26-08 Revised: 04-30-09 Cell Clipper tool This tool can be accessed from the Geopak: D&C Manager, as shown at the right. (If the item is not found as shown below, use the D&C > Edit > Find tool to locate it.) The Cell Clipper program was designed to reduce the size of a “Tabulation cell”, (such as 105-4), to a height that is somewhat shorter than the “full sheet height”. The program uses a MicroStation “fence border” to “clip” away the unwanted bottom portion of a design plan Tabulation cell. It then returns the remaining elements to “cell status”, as described in the program dialog, shown at the right, Page 1 of 1




(5.00 out of 5)



(5.00 out of 5)



(5.00 out of 5)



(5.00 out of 5)



(5.00 out of 5)



(5.00 out of 5)



(5.00 out of 5)



(5.00 out of 5)



(5.00 out of 5)



(5.00 out of 5)



(4.50 out of 5)



(4.00 out of 5)



(4.00 out of 5)



(3.50 out of 5)



(3.50 out of 5)



(3.00 out of 5)



(3.00 out of 5)



(3.00 out of 5)



(3.00 out of 5)



(3.00 out of 5)